tail end bearing

[poolshark743]

So i took my tail shaft apart today and found my problem. On the tail shaft there are 3 bearings. The middle one was shot to *&%^/ The race for the bearing had a huge gouge in it and every single bearing in that area was scored. Since I have that part of the tranny apart I decided to change out every bearing since I get wholesale price from the dealership, my friend is manager of parts. Thanks for all the info and advice from everyone. I will post pics of the bearings and update once the car is put back together.

[repiv]

Sorry to hear it wasn't the "simple" job of just changing out the rear one.

[poolshark743]

You still have to remove the tail shaft cause there is no way to get the tail end bearing out without doing so. But its cool I feel the job is done right by doing it this way.

[poolshark743]

i replaced every tailshaft bearing and also replaced the locking nut and all washers. After much beer the total cost was around $140 which looking at the work wasn't bad at all. It drives better than when I bought it. I am getting absolutely no noise and no vibration. Satisfaction I tell ya, satisfaction.